POJJO VVS-10012 Bedienerhandbuch PDF herunterladen (Seite 8)

Included in the kit is a 12” velcro strip. Cut a piece to t between each two quick

release knobs. The male side has vertical bers while the female side is fuzzy. Place

the male side on the false panel surface. Place a smaller female strip on the side of

the plug, keeping it away from the plane containing the plug prongs. If your

appliance is designed to be continuously plugged and you only wrap the remaining

cord, wrap the female velcro around the piece of cord that is last to be wrapped

around the knob to secure it in place. Make sure to wrap more than 361 degrees of

velcro tape for the female. This will ensure that this piece doe not come o.

Step 6: Add hinges to opening and false panel

The hinges are designed to install inside the false panel opening and attach to the

false panel. Place the hinge against the bottom corner of the opening and add a

screw to the top hole, and one to the bottom located on the 3/4” wood. Do this for

both hinges. Close both hinges.

Measure the dimensions of the false panel. (L1 x H1)

Measure the dimensions of the false panel opening. (L2 x H2)

Subtract the length and height dierences and divide by 2 to determine the amount of

overlap.

(L1 - L2)/2 = Left and Right gap

(H1 - H2)/2 = Top and Bottom gap

Place the false panel over the opening in the exact location and mark the top hole of the

hinge on the panel. Open the hinge completely and place a screw in the top hole. Do

this to both sides and ensure the panel closes in the correct spot. If satised screw in

the second hole. If hinges are torqued, they will not close. Try loosening screws and

adjusting to ensure the hinge is straight.

Step 7: Add Velcro to distance between knob pair

We recommend you install magnets on the top right and left corners or place one in

the center. When deciding the best location, aim to maximize the space between

quick release knobs.

Step 8: Adding a Latch

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

POJJO VVS-10012 Bedienerhandbuch Seite 8